ELECTRIC WINCH PROTECTIVE COVER

“WBC/S-2.0” is a current control device for winch motors with two operating speeds (high and low), which stops the winch when it reaches the current threshold set by a rotary switch.

By calibrating the intervention current value, it is possible to optimally control the tension level of the cable wound by the winch.
It is also possible to set the time limit (delay) beyond which the winch must be stopped.
The control unit is operated by two normally open buttons labelled "Command H" (high speed) and "Command L" (low speed).

COMPONENTS:

- 1 control unit in a fully resin-coated IP68 plastic box, dimensions 65x56x33mm.
- 1 Manual

TECHNICAL SPECIFICATIONS

Power supply from 10 to 32VDC, consumption without relay 32mA
Controllable motor power: up to 1500W at 12 VDC - Up to 2000W at 24 VDC
Can be used with any type of DC motor: 2/3/4 cables.
Maximum current sensor output 250 Amp
Current setting display with 16-position rotary switch
Minimum value displayable in "0" position 75 Amp with increments of 10 Amp at a time. Maximum value in "F" position 225 Amp
Intervention delay display via rotary trimmer
Minimum delay 1 sec. Maximum delay 5.2 sec
Protected against polarity reversal due to incorrect battery connection.